AUDIOLINE WAVE 10X Informações Técnicas descarregar pdf (Página 52)

Select this choice to view or change the settings for

advanced configuration options. These options

include enabling support for large hard disk drives

and support for drives with &ultra. speed.

To reset the SCSI controller defaults, press F6; then,

follow the instructions on the screen.

SCSI Disk Utilities:

To see the IDs that are assigned

to each SCSI device or to format a SCSI device, select

SCSI Disk Utilities from the SCSISelect Utility program

menu.

To use the utility program, select a drive from the list.

Read the screens carefully before you make a selection.

Note

If you see the following message, you might have

pressed Ctrl+A before the selected drives were ready.

Restart the server, and watch the SCSISelect

messages as each drive spins up. After the drive that

you want to view or format spins up, press Ctrl+A.

à ð

Unexpected SCSI Command Failure

Target SCSI ID: 4

SCSI CDB Sent: ð3 ðð ðð ðð ðE ðð ð7 ðð ð2 ðð

Host Adapter Status: ððh - No host adapter error

Target Status: ð2h - Check condition

Sense Key: ð2h - Not ready

+Sense Code: ð4h

+Sense Code Qualifier: ð2h

Press 'Esc' to continue.

Performing a Low-Level Disk Format:

You can

use the

Format Disk

feature of the SCSISelect Utility

program to perform a low-level format on hard disks.

Depending on the hard disk capacity, the low-level format

program could take up to two hours.

When To Use the Format Disk Program:

Use the

Format Disk program:

 When you are installing software that requires a

low-level format

 When you get recurring messages from the diagnostic

tests directing you to run the Low-Level Format

program on the hard disk

44 IBM Netfinity Servers HMM

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 151 152

Comentários a estes Manuais

Sem comentários

AUDIOLINE WAVE 10X Informações Técnicas Página 52

Comentários a estes Manuais