AUDIOLINE WAVE 10X Informações Técnicas descarregar pdf (Página 93)

Notes

 The microprocessor in the server comes with an

attached heat sink. The microprocessor plugs

into the primary microprocessor socket on the

system board and is stabilized with a plastic

bracket attached to the system board.

The type of heat sink in the server might be

different from the heat sink shown in this

procedure.

 When you add a second microprocessor, it must

operate at the same speed as the primary

microprocessor. For information about the

appropriate switch settings, see “Microprocessor

Speed Switches” on page 99, or see the label

inside the server cover. To locate the

microprocessor switch area of the system board,

find the configuration switches section of the

system-board illustration. See “System Board”

on page 96.

To install a microprocessor:

1. Remove the server cover (see “Side Access Cover”

on page 94).

2. If the server does not come with an air baffle, go to

step 3 on page 86.

If the server comes with an air baffle, remove the air

baffle:

a. If cables are in the way, move them.

b. Locate the three small levers on the air baffle

that protrude through the holes on the rear of the

server.

c. Press the levers down, toward the bottom, until

they unlock.

d. Slide the air baffle away from the rear of the

server.

e. Tilt the air baffle toward the microprocessors,

and slide it out, under the metal bar and away

from the two microprocessor/heat-sink

assemblies.

f. Remove the air baffle from the server, and save

it for later use.

IBM Netfinity 3500 - Type 8644

1 2 ... 88 89 90 91 92 93 94 95 96 97 98 ... 151 152

Sem comentários

AUDIOLINE WAVE 10X Informações Técnicas Página 93